Hub bearing

[mickh]

Does anybody know where I can get a front hub bearing from. This is the bearing that supports the drive shaft to the hub not the wheel bearings. Vauxhall can get one from Germany which will take 5 working days but I am impatient and want one now.

[RatCav]

Do you mean the needle bearing the CV joint runs on inside the steering knuckle stub?

If so Milners stock genuine Isuzu, or Isuzu can get them next day.

[RatCav]

Part "3"

Part number 94407708 (Isuzu Part Number 8944077080)



Worth getting the thrust washer as well. They are only a couple of quid.

Worth noting Isuzu are only £1 more expensive .. and don't charge £5,000,000 delivery

[stretch]

Beat me to it lol, I think milner do them but not sure on the quality.

[RatCav]

[mickh]

Thanks men you nailed it. Neal where do I get the Isuzu ones to save on the postage if its too high.

[stretch]

http://www.isuzupartsstore.co.uk/about/
http://www.hammondgroup.co.uk/pages/isuzu/parts

[snapper]

Same job as me, using Milner's parts.

[RatCav]

[mickh]

So far so good. Ordered the parts from Milners thursday night and they duly turned up today via good old Yoda. They look the right parts so fingers crossed.

[RatCav]

Good luck getting the old ones out. The washer should be easy to pull out past the seal.

The needle bearing is different. I ended up making a drift tool to push it out from the other end (wheel side).

When you look inside the stub you will see the bearing sits in a larger diameter step. I took a chisel and ground the end flat. I then ground the side to have an angled notch. I plan on doing mine tomorrow so will take photos.

[RatCav]

This is what I use to drift the bearing out. You drop it in front the front and put the notched bit up against the back of the needle bearing and tap, move around 90 degrees. tap, move round 90 degrees etc etc etc.

Just done one and it came out a treat.