bigger than mine!

hi
i had a n reg fronty park next to me today and it stud higher than mine the bloke said it was standered so why could this be?

Your torsion bars may have sagged, did you have much in your car weight wise? was he lying :lol:

if it was an N reg ....it would be on coils .....so would sit a tad higher than one on cart springs ...

or he was lying

the back wasn't worth mentioning but the front was quite a lot.

sounds like he's wound up his torsion bars a bit .....

or mine is low, would the bull bar make a differance?

I reckon the Bbars will make a tiny bit as they have some weight in them, probably not that noticeable though, the guy could have lots in the rear of the car forcing the front higher.

Yes.

The bull bar adds additional weight to the front, thus lowering it.

Different engines are different weights and can affect height appearance on sagging torsion bars.

Also, the leafers had optionally larger tyres that make them look a little taller than coilers.

Also, the wheel arch trim on leafer Estates is narrower than that on Coiled Estates, giving the illusion of more height.

The Haynes manual describes the process of checking and adjusting the correct front ride height.

Lawrence

He knifed all your tyres. :lol:

I was just going to say he may have bigger tyres :lol:

Or, he may have stolen his wheels. :lol:

Or, someone may have stolen his engine. :lol:

the v6 is the way to go

nah keep your v6s , 2.4 all the way :butt:

howdidleydo.

i have just checked the measurements of the ride height has it says in the haynes:

dirver's side = A 290mm, B 180mm, z 110mm (z should be 130mm)

passenger side is = A 300mm, B 190mm, z 110mm (z should be 130mm)

so mine is 20mm to low on the front which is why it looked lower, but does it matter that even though both sides are the same height the way it got there is different?