WHAT YOU DID TO YOUR TRUCK TODAY!

Today I purchased a tree strop and a snatch block for my new winch. I should never get stuck again :thumbup:

Colley we need to do the woods at Bala again

Fitted the spacers I got from Phil (aka Hound Dog) Now needing to get some bigger tyres again :lol:

and some longer shocks asap :shock:

took delivery on my new springs courtesy of mark (mgautos)

bet you can guess what im doing tomorrow

ill post up once i finished it.

Sad day today the first time ive ever had to SORN a vehicle and its me truck!!! Gutted! :cry:

Give a date Bobby, we will be there, you know that :thumbup:

Mine is having a burst of youth, its never felt as fast to drive, it just wants to go faster all the time :shock:

lovin it

Need a dry warm day Ste and at the moment they seem to be few and far between!!!

I know what you mean Bobby, but keep the force, we can sort it mate :thumbup:

Last edited by 4x4 bobby on Sat Jan 21, 2012 12:22 am, edited 1 time in total.

Thanx Bud!! :wave:

I know Rob will help and Jay said he would aswel so with the four of us we could do it in a day easy. Ive got the 3 piece clutch kit, rear crankcase oil seal and the spigot bearing just got to get the new oil. Do they make a seal kit for the clutch slave cylinder Ste??

You just shout matey

Two days would be good so I can be more than useless on at least one of them :party:

Well tomorrow I'll be doing....
Welding up my exhaust flanges so they meet in the middle (Theres about a 6 to 8mm gap in the middle due to warping

, safe to say its blowing a little lol)
Oil and filter change
New front bearings
New front brakes, disks and pads
Bleed entire braking system because it feels a little spongy and I can press the pedel all the way to the floor :/
Check my upper control arm bushes and swap with Angelina 2.0's if needed
Maybe flip my ball joints in prep for my 3" suspension left I have planned
Check rear brakes are ok
Give it a general once over

..::then::..

Book its MOT

Then next month I'll set about changing the front crank seal....AGAIN :evil:

Good luck Hippo :thumbup:

Any questions ask in appropriate forums and the guys will do their best best matey

Thank u ste, unfortunately I have already done most of the above jobs before, useing the info on here

In that case, hats off to ya fella :clap:

Now...make the old girl pass :thumbup:

Good luck Hipo!

You know your always welcome to pop over and we can have an East Anglian spanner party if needs be.

I would but this weekend if my last change to do it before the MOT runs out, also judging by the real nice sounds and vibrations thru the floor pan the bearings might not get to norwich

bobby....
more than happy to have a run over and give a hand mate.. just let me know when u have in mind.. :wink:

I gave Christine a coat of satin black paint not a bad job considering i used rattle cans.

you said it andy get some up :wink: