WHAT YOU DID TO YOUR TRUCK TODAY!

What a star :dance:

We will have a blanking party :lol:

2.8's invited only :wink:

Sooty,do you have front & rear recovery points bud ? if not then they would be highly advised to be done for the lake district trip :wink:

it bird poo season i had a few direct hits on my window an bodywork mind you Marvins is bogging you hardly notice im trying to resist washing it but i got the focus washed and it frigging shiny as so i want them to match

There is always one :lol:

A grand day out on Sunday and everyone was heading for the sea. As there was parking available for about a third of the cars about 50 cars headed for a nice grassy slope. But with winter and ice only hours away the nice grass soon turned to mud, deep mud, and we had literally a lot of stuck cars. I was happy to use some Frontera power and pulled out two sedans which had foolishly ventured off the road.
Very nice to be able to help :-D

I wind up the front torsion bars by another 1.5" to day, 3" and abit in total now.

Jason, you wont have any droop and the car will hop every where, not to mention your camber :shock:

ok go on..

What is the limit on these then i have got 2"+shocks going on front this thursday

you can get them to 3" and there not to bad,

tbh, a ball joint flip has mad no differnce to the camber, so i will be case of de-shiming, or droping it half an inch

It justs bounce about a bit but,it should be ok when I get the shocks on.
It is 3f up on the front arch and the back is 37" and a bit

See

http://www.youtube.com/watch?v=vKHiPbc0 ... _embedded#

viewtopic.php?f=32&t=28284&p=315489&hilit=+camber#p315489

viewtopic.php?f=5&t=27939&p=311620&hilit=+camber#p311620

viewtopic.php?f=32&t=27913&p=311411&hilit=+camber#p311411

viewtopic.php?f=6&t=25318&p=284492&hilit=+camber#p284492

replaced rusty rear bumper with a better one that alex give me, wish i hadn't as when i unbolted the bolts the tow bar was so badly battered that the holes wouldn't realign so had to go to big red fronty's as i hadn't got big enough sockets to remove the tow bar finally got it done.

what i thought would be a 30 minute job took a fair few hours and i blame you alex :twisted:

don't give me anything else :lol:

Thanks Drift
I will have to have I think