2" lift easy or not???

how easy is it to do. at the front end do i have to drop the bottom ball joints?

you dont have to touch the ball joints, but for a bit more drop, you can flip the top ball joint, understanding the word flip, just means taking it from its location and placing it under the top wish bone, and the wind the torsion bars up 8 turns, clock wise, if you are using the 2" spaces for the back, it will take about an hour, ish.

hmmmm i got some 2" spacers in my shed (just by chance :wink:

)

i. i know this to be true weaver just waiting to pay day and be having these from you

since this has not been touch since it came off the factory floor its going to damn tight is it not?

you will be fine mate ive seen em fitted in about 20 mins easy peasy :wink:

i hope so

pick ups almost finished.
get some new muddy's lift. and we will be done.
bucketed down this morn. and its still dry inside so there's some luck on my side.

Hi Bud

2" lift was easy with spacers from Alex, was just looking through some of my old posts for the step by step pics
from when we did mine but cannot for life of me find them. :oh yer:

Word of warning, be prepared to replace the ball joints as you will most likely wreck them splitting them to flip :wink:

The will wear out soon anyhow if they are old so may as well be replaced

cheers dave :-)

starting there journey tomorrow mate :wink:

wouldnt mind a set of spacers myself but would this throw the back axel out of line? and would the load compensation valve work as it should?

with 2"you dont have to touch anything :wink:

cool

do you have any left and if so how much?

thanks k

can i ask where you brought the spacers ? i know that id probably need a different size or whatever but i aint got a clue where i would go to get some !
also did you just wind up the torsion bar at the front ? and that was job done ?

I got mine from Alex whilst at Bala. He fabricated them for me and others to there spec. You could try a PM to him to see if there is any more and then the torsion bars wound up to match the 2" spacers. :wink: