Flexi induction pipe

HI folks,

I need some flexi induction pipe to run from my air box to raise the air intake level for when I'm wading. Something that looks something a bit like this I guess http://cgi.ebay.co.uk/Flexi-Induction-C ... 2708wt_907

I've no idea if that is the right diameter I need, I will measure it tomorrow, but what I could do with knowing is where i might get some tomorrow ? Is it a car spares place ? Building supplies ? Any ideas where I could get some 'off the shelf' ?

Cheers

65mm or at a push 75mm should do it.

This is good stuff, and remember sealant and to block the drain hole in the bottom of your air box.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... K:MEWAX:IT

And for ref, my contraption :lol:

Ahhaa ermmm a strong possibility taking into account your location is an agricultural supplier?

Dunno, had a hell of a job thinking what it was called when I tried getting some, kept finding rubbish pond hoses.

Some of the names I could find :wink:

http://uk.rs-online.com/web/search/sear ... breadCrumb

Yikes, £65 for 5m roll. I hope the local bods sell it by the metre :shock:

Just one more point , am I better to bend the open end near the bulkhead down ? (rather than up)

I have mine as level as I can, the turbo will suck anything passing in anyway, dont be tempted to put your hand on the end and rev the engine, it will fold like a concertina in a mili second and dissapear :lol:

So we know you will try it :lol:

Use zip ties to secure it in place and any areas you think it may possibly chaff just lop a big load of duct tape around it.

Oh, a metre is more than enough :wink:

Cant remember the set up in yours, do you have an engine bay piccy

Red would be the way to go, or green if the pipe will fit (doubt it) but keep the entrance to the hose back from the bulkhead to allow any water over the bonnet to drain down without hitting the hose entrance.

Red is preferable as it points away from any splashes.

Nice one, cheers Ste. Just gotta find some pipe tomorrow and I'm away

if you are struggling to find some I have some 65 mm heat proof steel wire reinforced flexy pipe. I can pop you some in the post if you need. I supplied some to mrtom last weekend and he seemed happy with it.

i seem to remember getting some from machine mart ...it was listed as heavy duty pump drainage hose or something along those lines ...i used it on the old vec as a cold air feed from the lower bumper

i used this, as i found it sits on the cone filter,
http://cgi.ebay.co.uk/80mm-3-3-16-Cold- ... 20b03a9cc0