I have to moan about Milners

banter general discussions etc

Re: I have to moan about Milners by yaki on Sat Apr 10, 2010 10:32 pm
Bought a centre and tail pipe off Milners 3 years ago, still not too rusty and no holes despite having a fairly hard life.

Have always found their service and parts very good, did have a CV boot fail after 10 months, rang them up and they sent me out 2 new ones free of charge 8)
Soon to be without a Frontera after 10 years of owning one :-(
User avatar
yaki
Lord frontera
Lord frontera
 
Posts: 2315
Joined: Mon Mar 26, 2007 6:17 pm
Location: South Wales
Model: 2.8 TDI Sport 3dr
Registration Year: 1996/P
Vehicle Name: Eric
Modifications: A few

Front Winch & Bumper
MR2 Seats
+4" Springs
+4" Rough Country Shocks
Calmini Front Arms
Trooper Front Axle
Front Aussie Locker
Rear Trooper Axle
Rear Aussie Locker
35mm Diff Drop
12mm Ball Joint Spacers
33" Tyres
80mm Body Lift
Extended Axle Breathers
Aisin Manual Hubs
Rear Recovery Bumper
Braided Brake Hoses
EGR System Removed
DeCat
Fuel Tank Lift
Front & Rear Anti-Roll bar removed
Roof Console
EGT/Boost Gauge and Inclinometer in Centre Console
Region: South Wales

Re: I have to moan about Milners by Valerian on Tue Apr 13, 2010 6:54 pm
Well...did speak to Milners yesterday and they have sent new parts out today.
Didn't get any apology though.

The exhausts are made by GT Exhausts in Ireland and i have now emailed the pictures to them direct.
Lets see if they have anything to say :|
User avatar
Valerian
Senior Frontera Engineer
Senior Frontera Engineer
 
Posts: 161
Joined: Wed Mar 18, 2009 10:20 pm
Location: North Devon
Model: 2.2i 16v RS Sport 3dr
Registration Year: 1999/V
Modifications: None yet and i don't really plan to do any. Those days have gone *smirk* but who knows what might happen in the future *grin*.
Region: South West

Re: I have to moan about Milners by Valerian on Sat Apr 17, 2010 11:27 pm
Well....i fitted the rear and middle box today. Still not happy with the quality but there you go.
Joining the middle to the front pipe was a joy seeing as the new mid section is a smaller bore than the old fiited front cat section.
Had problems with the joint not sealing properly but all seems fine now (fingers crossed)
I'll soon find out if it's going to stay sealed because tomorrow i have to do a 500 mile round trip. :shock:
User avatar
Valerian
Senior Frontera Engineer
Senior Frontera Engineer
 
Posts: 161
Joined: Wed Mar 18, 2009 10:20 pm
Location: North Devon
Model: 2.2i 16v RS Sport 3dr
Registration Year: 1999/V
Modifications: None yet and i don't really plan to do any. Those days have gone *smirk* but who knows what might happen in the future *grin*.
Region: South West

Re: I have to moan about Milners by Valerian on Mon Apr 19, 2010 6:43 pm
Had no reply at all from GT Exhausts. No surprise there then :|
User avatar
Valerian
Senior Frontera Engineer
Senior Frontera Engineer
 
Posts: 161
Joined: Wed Mar 18, 2009 10:20 pm
Location: North Devon
Model: 2.2i 16v RS Sport 3dr
Registration Year: 1999/V
Modifications: None yet and i don't really plan to do any. Those days have gone *smirk* but who knows what might happen in the future *grin*.
Region: South West

Previous

Return to General discussion

Who is online
Users browsing this forum: No registered users and 73 guests