by martin.holt4 on Fri Jul 21, 2017 8:28 pm
Hi there. I'm contemplating doing the same job on my 2001 3.2 Ltd. which has been intermittently running too hot for a while. I'd be grateful for some further advice if you don't mind:
I think the body of the inlet manifold is held down by 4 bolts, so these shouldn't be too difficult to remove. I guess I need to disconnect the injectors/hoses, throttle cable etc and lift the whole unit off? Or, do I need to take the throttle body off the manifold, or the top section (think it's called a collector) off the manifold?
Do I need to remove what calls itself a thermostat housing i.e. the unit supporting the drive belt pulley with all the sensors in (but not actually housing the thermostat!)
Where can I find a decent supplier of gaskets? Not much on ebay except a few in Australia and GSF have drawn a blank.
Many thanks in advance
Martin